Install the control horns onto the rudder and elevator. Note that if you are using pull-pull rudder, you will
need to install control horns onto both sides of the rudder. If you are using gas power, you will only need
one horn, on the right. Note also that your elevator horn will be on the elevator half on the left side of the
fuselage. Use 30-minute epoxy to install these horns. Remove the covering over the slots for the horns,
liberally apply epoxy to the slots and the bottom of the horn, press in, and remove excess epoxy with a q-
tip soaked in rubbing alcohol.
Locate and open the hole in the rear of the fuselage for the lowest rudder hinge, as shown.