Pannoramic 250 1.15 User’s Guide
5 Troubleshooting and Maintenance
5.3 Maintenance
This section describes the most common maintenance solutions that can be performed by the user of
the product. For maintenance solutions not described in this manual, contact the service personnel.
5.3.1 Opening the protective cover
To perform maintenance work and when slide or magazine jamming occurs, the protective cover(s) of
the Pannoramic 250 need to be opened in order to eliminate the problem. Before opening the cover,
exit the control software, switch off the main power supply and disconnect the power cables (see
section
1.1.4 Main parts of the Base Unit
).
Warning!
The opening mechanism is operated by a pre-tensioned hinge. Be sure
that before opening the protective cover, open the FL cover first, so it
will not lash to the cover during opening. For information on how to
open the FL cover, see section
Figure 77 – Opening the cover
To open the cover, you will need a maximum 3mm diameter, 50 mm long screwdriver.
1. Insert screwdriver
(2)
in the cover opener hole
(1)
aligned 30 degrees upwards and parallel
to the side of the base unit.
2. Press the cover opener button with caution with the screwdriver.
3. Open the cover.
4. To close the cover, push down the cover on the right side (above the lock) until you hear a
clack sound.
March 13, 2012 – Rev. 1
3DHISTECH Ltd.
120
(
135
)
