3D Systems Sinterstation Pro, User Manual, Page: 222 / 280

SLS p r o c e s s 2 2 2 B O S
u s e r ’ s g u i d e b r e a k o u t s t a t i o n m o d e o p e r a t i o n s
BOS Operation Tips
`
The sifter level sensor can be seen from the
RCM bay. (See image below.)
`
The hopper level sensor can be seen from the
right rear side of BOS, with right side access
panel removed. (See image at right.)
`
The left air-slide air flow is only turned on in
Breakout Station mode—and only when
hopper is empty (level sensor off ). The left
air-slide air flow is off
In Standby mode, and
when the hopper is full (level sensor is on).
`
The auger and sifter motors are coupled.
They can be controlled separately, but the
BOS controls them as a pair and they always
run together.
BOS sifter level sensor viewed
from front of RCM bay.
BOS hopper level sensor viewed
from right side of BOS