3D Systems Sinterstation Pro, User Manual, Page: 17 / 280

SLS p r o c e s s 1 7 S A F E T Y
u s e r ’ s g u i d e e l e c t r i c a l s a f e t y
E l e c t r i c a l S a f e t y
To prevent electrical shock, SLS equipment will
not operate unless all external panels are
installed and all electrical safety interlock circuits
are closed.
All SLS equipment was designed to minimize
operator exposure to electrical hazards during
normal operations. All exposed electrical circuits
are inside limited-access cabinets. This is to
separate the operator from service and
maintenance areas.
When operating any SLS equipment, keep the
following electrical safety points in mind:
✓
Only 3D Systems certified service personnel
should operate SLS equipment with access
panels or service doors open.
✓
Heed high voltage warning signs and labels.
✓
Take common-sense safety precautions when
operating any electrical equipment.
✓
After any change to the electrical wiring,
make sure the equipment is properly
grounded.
Hazardous voltage exists inside the
enclosures of all SLS equipment.
Injury or death from electrical shock
can result if you remove external
panels or try to defeat safety
interlocks. Panels should only be
removed, and interlocks should only
be defeated, by trained and certified
3D Systems Customer Support
personnel.
Verify your facility’s electrical service
ratings
before connecting power to
any SLS equipment.z Power must
only be connected by certified
electrician.