28
3D Systems, Inc.
REMOVE PART FROM PRINT PLATFORM
To remove your part from the print platform:
•
Place the platform in a freezer for ten to fi fteen minutes. As the parts and platform cool, they contract at different rates and separate.
•
Alternatively, the parts can be mechanically separated from the print platform by force using a tool with a stiff thin blade such as
a putty knife. Make certain you do not mark the platform. For more information on how to clean parts, refer to the VisiJet Post
Processing Guide.
REMOVE PRINT PLATFORM
When touchscreen shows DONE: <job_name> remove print platform
1. Open the chamber door.
2. To remove the platform, Pull the platform forward until you feel it
contact the stops.
3. Place your hands on either side of the platform to lift and remove it
from the 3D printer system
EMPTY WASTE DRAWERS
Personal protection equipment is required before opening waste drawer. Follow all material handling and disposal
guidelines. Always follow Global Health and Safety guidelines and local regulations regarding handling and
disposal of regulated materials. Keep disposal records if local law requires.
CAUTION: Wear protective gloves and sleeves before removing any waste material. Be careful not to spill, drop, or
expose others to these materials. Dispose the material according to your local regulatory guidelines.
NOTE: When removing the draped portion of the bag, be careful not to spill the material that may be on the top portion of the bag.
1. Open the upper left and upper right MDM.
2. Slide both waste drawers completely out of
the 3D printer system.
3. Remove waste bags from waste drawers and
place into a hazardous waste container.
4. Replace the plastic waste bag for each
drawer.
5. Close waste drawers and press the
Start
to resume.
