UP Plus 3D Printer User Manual
4.1 Extruder Vent
The lever that is located on the extruder vent “Wind barrier”
Door Closed
•
Each printed layer bonds to
layer better, making for a
•
The under sides of printed curves have a
rougher finish.
•
Recommend for large parts
•
Support material is harder to remove.
•
The heated platform is not affected by
the airflow, so reduces warping of the
raft from the platform.
open during pre-heating can cool the
platform unevenly thus resulting in
warping.
The above is a heat temperature
in the centre below the platform, it takes a while for the heat to reach the corners. It is best to i
sulate the platform during pre-
4. Troubleshooting
3D Printer User Manual v 2013.6.10
4.1 Extruder Vent “wind barrier”
The lever that is located on the extruder vent “Wind barrier” does the following:
Door Open
Each printed layer bonds to the previous
making for a stronger part.
The under sides of printed curves have a
Recommend for large parts.
Support material is harder to remove.
The heated platform is not affected by
the airflow, so reduces warping of the
raft from the platform. Having the door
heating can cool the
platform unevenly thus resulting in
• Each printed layer bonds to the previous
layer less, making for a weaker part.
• The under sides of printed curves have a
smoother finish
• Recommend for small and intricate
• Support material is easier to remove.
• Delaminating can occur in the model, try
with the door closed.
• Recommend to keep the door closed during
pre-heating of the platform, and open the
door after the raft section has been co
pleted to reduce chances of warping.
• Recommended open with the
ments
temperature map image after 20 minutes of preheating. As the heater is located
in the centre below the platform, it takes a while for the heat to reach the corners. It is best to i
-heating especially when printing large parts.
Troubleshooting
Each printed layer bonds to the previous
less, making for a weaker part.
The under sides of printed curves have a
small and intricate parts
to remove.
Delaminating can occur in the model, try
to keep the door closed during
heating of the platform, and open the
t section has been com-
pleted to reduce chances of warping.
with the
Value Fila-
. As the heater is located
in the centre below the platform, it takes a while for the heat to reach the corners. It is best to in-
