UP Mini 3D Printer User Manual
3. Operation
3.1 Preparation
3.1.1 Quick Setup
1.
Remove the two packing foam
and lift up the platform and remove the second from under
the platform.
2.
Clip on the roll holder onto the back of the printer.
3.
Mount the Extruder Head
head into its magnetic clip bracket. The fan sits on the
left hand side as per image 3. Then plug in the ribbon
cable connector on the top of the head.
4.
Open the foil bag that contains
3D Printer User Manual
Quick Setup
packing foams from the inside back wall
lift up the platform and remove the second from under
holder onto the back of the printer.
Mount the Extruder Head, by clipping the Extruder
head into its magnetic clip bracket. The fan sits on the
left hand side as per image 3. Then plug in the ribbon
cable connector on the top of the head.
Open the foil bag that contains the ABS filament.
NOTE:
Do not let go of the end of the filament,
otherwise it will unravel
which will then cause a block in the extruder head and
several hours of unwinding the spool manually to find
the knot!
13
Do not let go of the end of the filament,
unravel itself and tie itself in a knot,
which will then cause a block in the extruder head and
several hours of unwinding the spool manually to find
