3D Platform
WorkSeries 200, 300 & 400 Manual
Revision: B
Date: December 28, 2017
3dplatform.com
• 3DP
-DOC-005 (12-2017)
14
3.
Plug in Attachments
4.
Attach Wiring to the Base Unit
a)
Locate the power outlet location toward the
right, rear side of the base unit.
b)
Plug in the cord from the print bed unit into the
cart.
c)
Locate the power cord
—
stored within the
storage drawers of the 3D Platform
WorkSeries
—
and attach to the cart unit.
d)
Plug the power cord into the power outlet.
5.
Verify Emergency Stops (E-Stops)
Verify the E-Stops, on the front and rear of the
machine, are both disengaged.
6.
Initial Power Up of the Machine
Important!
Follow the initial actuator alignment process
PRIOR to powering the machine.
Power the machine after the alignment of the actuators
has been confirmed with the Initial Actuator Alignment
Process.
a) Turn the switch, located on the power outlet on
the base unit, to the ON position.
b) Press the green power button on the
control box.
Note:
To completely power-down and eliminate the draw of electrical
current, the power switch on the cart must be switched to the off
position.
Powering Up
1.
Turn on the power switch located on the base unit.
2.
Press the green power button on the control unit.
The power outlet on the base unit is located toward the
right, rear side. The control unit is located on the work
area toward the front of the printer.
In case of emergency, press one of the Emergency Stop
buttons (located on the front and rear of the machine).
Wi-Fi Connection Setup
1.
With the control box turned on, select the
“Console” tab on the touch screen.
2.
Select the keyboard symbol at the top of the touch
screen.
3.
Type
M552 S0
into the keyboard to turn off Wi-Fi
connection.
4.
Press the Enter symbol to run the command
(Repeat this step for following commands).
5.
Type
M552 S1
into the keyboard to turn on Wi-Fi
connection.
6.
On your computer or mobile device, open the Wi-Fi
(network) connections list.
7.
Select “Duet Wi
-
Fi” and connect.
Note:
If network does not appear, enter M552 S2 in Console
on touch screen.
8.
Open a web browser and type the IP address 0.0.0.0
into the browser bar.
Note:
If 0.0.0.0 does not work, try 192.168.1.1
9.
In the menu, select your local Wi-Fi network and
enter the network password.
10.
You should receive an “All Done!” message.
11.
Disconnect your PC or mobile device from the “Duet
Wi-
Fi” network.
12.
Power cycle the controller to complete the setup
(Black Button, followed by Green Button).
