3D Platform
WorkSeries 200, 300 & 400 Manual
Revision: C
Date: December 28, 2017
3dplatform.com
• 3DP
-DOC-005 (12-2017)
10
Safety Guidelines & Warnings
The following safety guidelines as well as the
instructions within this user manual ensure the safety of
the user while operating and maintaining the 3D
Platform WorkSeries 3D printer. If the machine is not
operated as specified, the operator's safety may be
compromised.
Installation
•
Connect the printer to the safety-certified power
cord supplied with the machine. The electrical
outlet should be near the printer and easily
accessible.
NOTE:
Make sure your outlet is installed by a qualified electrician.
•
Never connect the printer to an outlet that does not
have a ground wire. Disconnecting the ground wire
may result in electric shock.
Operation Guidelines
•
The 3D Platform WorkSeries 3D printer generates
high temperatures in the print nozzle and the print
bed
—
do not touch when hot. Allow the unit to cool
before touching.
•
Do not set objects on the heated print bed. Do not
lean or stand on the print bed. Doing so may cause
injury to the operator.
•
Due to high temperature outputs and moving parts,
the location where the printer is operating should
be equipped with working smoke detection and
flame suppression.
•
The 3D Platform WorkSeries 3D printer melts
material during printing. Some materials may
require ventilation.
•
Do not leave the 3D Platform WorkSeries 3D printer
unattended while in operation.
•
The 3D Platform WorkSeries 3D printer includes
linear actuators that move in multiple directions at
variant speeds. When in motion, they may cause
injury. Keep all items and persons clear of the
moving actuators, and avoid bumping or pinching of
moving actuators.
•
Do not place any body part near the print head or
nozzle, as injury may occur if pinched between the
print bed and the nozzle.
•
In case of emergency, use one of the Emergency
Stops.
Emergency Stop (E-Stop) Function
The E-Stops are located at the front left and rear right
corner of the machine. Pressing either E-Stop will
immediately halt movement of the actuators and will
prevent motion until the touch screen control box is
reset.
Caution!
Pressing the E-Stop does not remove power
from the machine.
To disengage E-stop, twist the button. After disengaging
E-stop, the touch screen control box must be reset. To
reset the control box, press the black button, wait 5
seconds, and then press the green button.