1-7
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure an NTP client
ntp-service
unicast-server
{
remote-ip
|
server-name
} [
authentication-keyid
key-id
|
priority
|
source-interface
Vlan-interface vlan-id
|
version
number
]*
Required
By default, the device is
not configured to work in
the NTP client mode.
z
The remote server specified by
remote-ip
or
server-name
serves as the NTP server, and the local
device serves as the NTP client. The clock of the NTP client will be synchronized by but will not
synchronize that of the NTP server.
z
remote-ip
cannot be a broadcast address, a multicast address or the IP address of the local clock.
z
After you specify an interface for sending NTP messages through the
source-interface
keyword,
the source IP address of the NTP message will be configured as the primary IP address of the
specified interface.
z
The device can act as a server to synchronize the clock of other devices only after its clock has
been synchronized. If the clock of a server has a stratum level lower than or equal to that of a
client’s clock, the client will not synchronize its clock to the server’s.
z
You can configure multiple servers by repeating the
ntp-service
unicast-server
command. The
client will choose the optimal reference source.
Configuring the NTP Symmetric Peer Mode
For devices working in the symmetric peer mode, you need to specify a symmetric-passive peer on the
symmetric-active peer.
Follow these steps to configure a symmetric-active switch:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Specify a symmetric-passive
peer for the device
ntp-service
unicast-peer
{
remote-ip
|
peer-name
}
[
authentication-keyid
key-id
|
priority
|
source-interface
Vlan-interface vlan-id
|
version
number
]*
Required
By default, the device is not
configured to work in the
symmetric mode.