SFP Operation
27
Figure 6
Inserting a SFP Transceiver
5
The transceiver connects to the network using a duplex SC connector.
Attach a male duplex SC connector on the network cable into the duplex
SC connector on the transceiver.
6
Connect the other end of the cable to a device fitted with an appropriate
Gigabit Ethernet connection.
7
Check the Module Active LEDs on the front of the Switch to ensure that it
is operating correctly. Refer to “LEDs” on page 14 for more information.
Removing an SFP
Transceiver
If you wish to remove a 3Com transceiver (it is not necessary to
power-down your Switch):
1
Disconnect the cable from the transceiver.
2
Move the wire release lever downwards until it is pointing toward you.
3
Pull the wire release lever toward you to release the catch mechanism;
the transceiver will then easily slide out.
The above procedure will release a 3Com SFP transceiver. To release a
transceiver from another manufacturer see the documentation supplied
with your SFP transceiver.
DUA1750-0AAA01.book Page 27 Friday, December 5, 2003 10:24 AM
Summary of Contents for SUPERSTACK 3 3226
