3Com Router 5000 Family
Installation Guide
Chapter 5 Startup and Configuration of the Router
3Com Corporation
5-3
Figure 5-3
Setting serial interface parameters
3) Set HyperTerminal properties. Select [Properties\Port Settings] in the
HyperTerminal to enter the properties setting window as shown in
Error!
Reference source not found.
. Select the terminal emulation type to be VT100 or
Auto detect, and click <OK> to return to the HyperTerminal window.
5.1.2 Powering on the Router
I. Checking before power-on
Check according to the following items before powering on the router.
z
Whether the power cord and PGND wire are correctly connected.
z
Whether the voltage of the power supply complies with the requirement of the
router.
z
Whether the console cable is correctly connected, whether the PC or terminal for
configuration is open, and whether the settings are done.
Warning:
Before powering on the router, the user should be aware where the switch of the power
supply to the router is located, so that the power supply can be disconnected in time
once accidents occur.
