1-14
C
HAPTER
1: NETB
UILDER
II 4-S
LOT
B
RIDGE
/R
OUTER
4
Remove the front panel.
a
From inside the chassis, remove the two screws from the panel.
b
Gently tip the panel forward.
c
Lift the panel out of the hinges at the bottom of the chassis.
Figure 1-15
Front Panel Screws in the 4-Slot Chassis
5
Disconnect the power wiring harness and the ribbon cable from the connectors
on the back of the floppy disk drive.
Figure 1-16
Disconnecting Cables from the Floppy Disk Drive in the 4-Slot Chassis
6
Remove the floppy disk drive and its bracket from the chassis.
a
From the front of the chassis, remove the two screws that secure the
bracket.
b
From inside the chassis, remove the screw from the back of the bracket.
c
Slide the bracket toward the back of the chassis and lift it and the floppy
disk drive out of the chassis.
7
Transfer the bracket from the original floppy disk drive to the new one.
a
Remove the four screws from the sides of the bracket (two on each side).
b
Slide the floppy disk drive out of the bracket.
c
Slide the new floppy disk drive into the bracket.
d
Reinstall the four screws.
Front panel
Screws
Inside front of chassis
Power supply
Disconnect power wiring
harness from disk drive.
Disk drive
Disconnect ribbon cable
from disk drive.
Back panel
Backplane
Front
a
b
Summary of Contents for NETBuilder II
