1-8
Technical specifications
Table 1-6
Technical specifications of NSQ1GT8C40
Item
Description
Memory type and size
DDR2 SDRAM
1 memory slot
512 MB (default), 1 GB (maximum)
8
10 Mbps, half/full duplex
100 Mbps, half/full duplex
Electrical interfaces
1000 Mbps, full duplex
4 (electrical/optical)
10 Mbps, half/full duplex
100 Mbps, half/full duplex
Electrical interfaces
1000 Mbps, full duplex
Combo interfaces
Optical interfaces
1000 Mbps, full duplex
Power consumption monitoring
Supported
z
A Combo interface is comprised of an electrical interface and a small form-factor pluggable (SFP)
interface.
z
For an optical/electrical Combo interface, the default operating interface is the electrical interface.
z
For a Combo interface, either the electrical interface or the optical interface can operate at one time.
You can use the
combo enable
{
copper
|
fiber
} command in interface view to switch between the
electrical and optical interfaces. For details about the
combo enable
{
copper
|
fiber
} command,
refer to
H3C SecPath Series Security Products
User Manual.
LEDs
Table 1-7
Description of the LEDs on NSQ1GT8C40
LED
Status
Description
OFF
No power input or the LPU is faulty.
Slow blinking (1 Hz)
The LPU is operating normally.
Fast blinking (8 Hz)
The application software is being loaded (in this state,
never power off the device or hot-swap the LPU; otherwise
the LPU may be damaged), or the LPU is not working.
RUN
(green)
Reset
The RUN LED goes off after the system is reset and
flashes fast on system startup.
