52
C
HAPTER
4: C
ONFIGURING
THE
A
CCESS
P
OINT
U
SING
A
W
EB
B
ROWSER
11
Enter the time in seconds for
Maximum PPP Terminates
.
This setting controls the PPP-terminate requests an AP issues when a PPP-linked AP
does not respond to a terminate request. The AP closes the PPP connection after
issuing PPP-terminate requests for the maximum time specified. The default is 10
seconds from a 0-255-second range.
12
Click
Modem Dialout
to dial the modem.
13
Click the
Modem Hangup
check box to have the modem hang up after a call.
14
Click
Clear Entries
to reinstate the default settings.
15
Click
Save Settings
to save your entries on this page.
Configuring the Answering Modem
1
Complete steps 1-3 for configuring the originating modem above.
2
Select
Answer
for
Modem
Connect Mode.
3
Complete steps 5-11 for configuring the originating modem above.
Filtering
In order to control the types of network traffic the AP handles or to eliminate
some network traffic, you can configure the AP to forward or discard particular
types of packets (TCP/IP, IPX). Or you can allow all traffic through by disabling the
filtering option.
1
Select
Configuration-->Filtering
. The
Filtering Setup
page displays.
2
Determine what type of filtering you want to set up and select the appropriate
procedure below.
Filtering to Forward Packets
To configure the AP to forward packets of particular types, do the following:
1
Click
Forward
as the
Type Filtering
.
2
Enter the four hex digits associated with the network protocol for which you want
the AP to forward packets.
3
Click
Add Filter
.
4
Repeat steps 2 and 3 to add additional protocol types.
5
Click
Clear Entries
to reinstate the default settings.
6
Click
Save Settings
to save your entries on this page.
Filtering to Discard Packets
To configure the AP to discard packets of particular types, do the following:
1
Click
Discard
as the
Type Filtering
.
2
Enter the four hex digits associated with the network protocol for which you want
the AP to discard packets.
3
Click
Add Filter
.
4
Repeat steps 2 and 3 to add additional protocol types.
5
Click
Clear Entries
to reinstate the default settings.
6
Click
Save Settings
to save your entries on this page.
