3Com 5500 SI - Switch - Stackable, Configuration Manual

Page: 17 / 686

17
26
RSTP C
ONFIGURATION
STP Overview 539
Implement STP 539
Configuration BPDU Forwarding Mechanism in STP 543
Implement RSTP on the Switch 543
RSTP Configuration 544
Enable/Disable RSTP on a Switch 547
Enable/Disable RSTP on a Port 547
Configure RSTP Operating Mode 548
Configure the STP-Ignore attribute of VLANs on a Switch 548
Set Priority of a Specified Bridge 549
Specify the Switch as Primary or Secondary Root Bridge 549
Set Forward Delay of a Specified Bridge 550
Set Hello Time of the Specified Bridge 550
Set Max Age of the Specified Bridge 550
Set Timeout Factor of the Bridge 551
Specifying the Maximum Transmission Rate of STP Packets on a Port 551
Set Specified Port to be an EdgePort 552
Specifying the Path Cost on a Port 552
Set the Priority of a Specified Port 553
Configure a Specified Port to be Connected to Point-to-Point Link 553
Set mCheck of the Specified Port 554
Configure the Switch Security Function 554
Display and Debug RSTP 556
RSTP Configuration Example 556
27
P
O
E P
ROFILE
C
ONFIGURATION
Introduction to PoE Profile 559
PoE Profile Configuration 559
PoE Profile Configuration Tasks 559
PoE Profile Configuration Example 560
28
SNMP C
ONFIGURATION
SNMP Configuration Introduction 563
SNMP Versions and Supported MIB 563
Configure SNMP 565
Enabling/Disabling SNMP Agent to Send Trap 566
Setting the Destination Address of Trap 566
Setting Lifetime of Trap Message 567
Setting SNMP System Information 567
Setting the Engine ID of a Local or Remote Device 567
Setting/Deleting an SNMP Group 567
Setting the Source Address of Trap 568
Adding/Deleting a User to/from an SNMP Group 568
Creating/Updating View Information or Deleting a View 568
Setting the Size of SNMP Packet Sent/Received by an Agent 568
Enabling/Disabling a Port Transmitting Trap Information SNMP Agent 569
Disabling SNMP Agent 569