3Com 5500-EI PWR, Reference Manual

Page: 312 / 1314

3-18
Use the
undo rip work
command to disable the interface from neither receiving nor sending RIP
packets.
By default, all interfaces except loopback interfaces are enabled to receive and send RIP packets.
The differences between the
rip work
,
rip input
, and
rip output
commands are as follows:
z
The
rip work
command controls the receiving and sending of RIP packets on an interface.
z
The
rip input
command controls only the receiving of RIP packets on an interface.
z
The
rip output
command controls only the sending of RIP packets on an interface.
Related commands:
rip input
,
rip output
.
Examples
# Disable the interface VLAN-interface 10 from receiving or sending RIP packets.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] undo rip work
summary
Syntax
summary
undo summary
View
RIP view
Parameters
None
Description
Use the
summary
command to enable RIP-2 automatic route summarization.
Use the
undo summary
command to disable RIP-2 automatic route summarization.
By default, RIP-2 automatic route summarization is enabled.
Route summarization can be used to reduce the routing traffic on the network as well as to reduce the
size of the routing table. The summary routes contain the natural masks when advertised.
If RIP-2 is used, route summarization can be disabled with the
undo summary
command when it is
necessary to broadcast subnet routes.
RIP-1 always uses automatic route summarization, but the
undo summary
command is invalid for
RIP-1.
Related commands:
rip version
.
Examples
# Set RIP version on the interface VLAN-interface 10 as RIP-2 and disable route summarization.
<Sysname> system-view
System View: return to User View with Ctrl+Z.