18
If you supply your own Ethernet cable for connecting power, be sure that it is
standard category 5 straight-through (8-wire) cable that has not been altered
in any way. Use of nonstandard cable could damage the access point.
U
SING
THE
P
OWER
S
UPPLY
The
power
supply can be located at any point between the access point and the
LAN access port, wherever a convenient power outlet exists. If you supply your
own Ethernet cable for connecting power, be sure that it is standard category 5
straight-through (8-wire) cable that has not been altered in any way. Use of
nonstandard cable could damage the access point.
Refer to the illustration above, and follow these steps:
1
Connect one end of the Ethernet cable to the Ethernet port on the access
point.
2
Connect the other end of the Ethernet cable to the port labeled
To Access
Point
on the power supply.
3
Connect the power cord to the power supply and plug the cord into a power
outlet.
"To Access Point"
"To Hub/Switch"
Using the Power Supply
Using A Power-over-Ethernet
LAN Port
CAUTION:
To avoid damaging network equipment, make sure that the cables
are connected from access point to power supply to LAN as shown above and
described below.
