Manual WS.502 v1.5
2-Wire Energy Monitor
25
13. OPERATION
Go to
'EXIT'.
The page is now reloaded and you can
see the following:
On the left are the group names, and some more
menus for visualizing the logs. On the right, the
channels come in the order as we would have liked.
Clicks on a group on the left may close other open
groups and open the requested group.
Right, click the group names opens or close the group.
When consumers are connected and active, a
measurement is made every minute.
However, the page as you see them now will not show
the measured values. If you want to keep an eye on
them, you can 'refresh' the page.
Press
'AUTO REFRESH',
and every minute you will
now see the newly measured values.
Each channel now shows the most important things:
consumption, daily consumption, annual
consumption. (or temperature.. CO2...)
N
OTE
.
W
HEN A
'
GRAPH
'
IS SHOWN
,
THERE IS NO
'
REFRESH
'
OF THAT CHANNEL
!
The TP.16A thermostat allows you to change the set
point. On the far right is the 'set point', and to the left
of it is the 'room temperature'. By pressing one of
them you can increase or decrease the set point per
half degree.
For relay control (mode = TOGGLE
–
BISTABLE) there
isan ON-OFF key.
At the AIR.04 we see the room temperature,
humidity, air pressure, IAQ, and an indication of air
quality: VERY GOOD
–
GOOD
–
MODERATE
–
POOR
14. GRAPHS
CONTROL:
Clicking on a consumer's name shows in chart the
daily consumption of that consumer. By
'hovering'
over the graph we getto see a
'tooltip'
with the
measurements of that time.
By clicking the name again, the month chart is now
shown.
On the right are 2 arrows <<< || >>> Allows us to go
back up to 7 days with the daily overview, or up to 12
months with the monthly overview. Clicking back
closes the chart.
Note. Opening charts for the first time can
take a few seconds (according to the speed of