Operation
2-4
Power
To supply power to a HV ANSI Series terminal:
1.
Plug one end of a
into the modular connector on the bottom of the
terminal. Plug the other end into the
Figure 2-5: Cable Connections
Bottom of Unit
Modular Cable
PCAT Adapter
Power Supply/
Battery Charger
2.
Using a Two Technologies’ power supply (such as a Two Technologies 1226-1 linear power
supply for units with a -2 power supply configuration), plug the power supply connector into
the PCAT adapter and then plug the power supply into a 120 VAC 60 Hz power outlet.
3.
The terminal should turn on and a blinking cursor should appear on the display. If the
terminal does not turn on, refer to the
section of this manual for help.
Display Operation
Standard HV ANSI Series terminals display the U.S. ASCII 96 character set. However, other character
sets, such as such as Latin 1 or European, are also available as an option. Characters appear on the
display at the current cursor location.
Cursor Position
Typically, the cursor moves from left to right as the terminal displays characters (unless altered by
Escape commands). The cursor is selectable as a block (enabled), hidden (disabled), blinking and non-
blinking.
Whenever a character appears in the last position of the top three rows, the cursor will move to the
leftmost position on the next row. By default, the terminal will hide the character in the last position on
the bottom row (Position 80) with the cursor until it displays the next character. In which case, the
screen will scroll up one row, the hidden character will appear in Position 80 and the cursor will appear
in the rightmost position on a new bottom row. As an option, you can display a character in Position 80
and hide the cursor before the terminal display the next character.
For additional information about cursor and display options, see
Chapter 3: Manual Configuration
, and