
2N Access Unit Installation Manual
93
/
107
•
•
To the switched output.
To the passive output in series with the external power supply.
The device also supports a Departure button connected between the
‘PB’
and
‘–
HeliosIP/2N IP
intercom’
terminals. Press the Departure button to activate the output for 5 seconds.
Status signalling
Green LED
Red LED
Status
flashing
off
Operational mode
on
off
Activated output
flashing
flashing
Programming mode – waiting for
initialisation
on
flashing
Error – wrong code received
Configuration:
Connect the
2N
®
IP Security relay
to the properly set access unit security output. For settings
refer to the
2N Access Unit
Configuration Manual
is installed. Make sure that one LED at least is
on or flashing.
Press and hold the
2N
®
IP Security relay
Reset button for 5 seconds to put the device in the
programming mode (both the red and green LEDs are flashing).
Activate the output switch using the keypad, telephone, etc. The first code sent from the
intercom will be stored in the memory and considered valid. After code initialisation, the
2N
®
IP Security relay
will pass into the operational mode (green LED flashing).
Summary of Contents for 01368-001
