2N 01368-001, Installation Manual, Page: 70 / 107

2N Access Unit Installation Manual
70 / 107
•
•
•
•
•
•
•
•
•
•
•
•
Static IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Wait until the red LED goes off and the acoustic signal can be heard (approx. for
another 3 s).
Release the RESET button.
The following network parameters will be set after restart:
IP address: 192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1
Dynamic IP Address Setting
Follow the instructions below to switch on the Dynamic IP address mode (DCHP ON):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Wait until the red LED goes off and the acoustic signal can be heard (approx. for
another 3 s).
Wait until the green LED goes off and the red LED goes on again and the acoustic signal
can be heard (approx. for another 3 s).
Release the RESET button.