EN
DE
FR
ES
IT
EN
DE
FR
ES
IT
4
5
Setting the Temperature
1. Plug in the iron. The power indicator light will turn red and beep. The iron will be in
Standby mode and “OFF” will appear on the LCD display.
Standby Mode
2. To select a temperature setting, press the Temperature Setting / button until
you reach your desired setting from 1 to 9.
Note:
See the fabric guide on the LCD display and read the garment’s label to help
you determine which temperature setting to use.
Tip:
If unsure of a garment’s fiber, test a small area (on an inside seam or hem)
before ironing.
3. The digital display will show the setting number and fabric type. The fabric type will
flash on the display when heating.
Temperature
mark
Fabric type
4. When your set temperature is reached, the iron will beep once and the fabric type
will stop flashing.
5. To change temperature settings while ironing, just press the Temperature Setting
button. When a lower setting is selected, fabric type will flash until the iron
temperature has lowered to the correct level for that setting.
LCD Display
Normal Status
Level 1 - Acrylic
Level 2 - Nylon
Level 3 - Silk
Level 4 - Polyester
Level 5 - Blended
Standby Mode
Level 7 - Cotton
Level 8 - Jeans
Level 9 - Linen
Auto Shutoff
Level 6 - Wool
Error Status
NTC short-circuit
NTC lower than 50°C
Soleplate over 270°C±15°C
• Unplug the iron from the power when the LCD panel shows an error status. Plug
the iron in again once the soleplate has cooled.
• If the LCD panel still shows an error status, contact qualified technicians to check
and repair the iron or contact our customer service.
Note:
NTC stands for Negative Temperature Coefficient.
