NIC Status Lights for xx60, xx55, and xx50 Appliances | 147
NICs for SteelHead CX, DX, EX, SteelFusion, and SteelCentral platforms
The interface names for the NICs in the SteelHead Management Console and the CLI are a combination
of the slot number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port
NIC is located in slot 1 of your system, the interface names are: lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
The following table describes the Four-Port LX/SX Fiber GbE SFP card status and LED lights.
Two-Port LR/SR Fiber 10-Gigabit Ethernet SFP+ card
This section describes the Two-Port LR/SR Fiber 10-GbE SFP+ card (410-00049-01) status lights. This
card is a standard NIC (without bypass functionality) for use with SteelCentral appliances.
Figure C-5. Two-Port 10-GbE LR/SR Fiber SFP+ NIC
The interface names for the NICs in the Management Console and the CLI are a combination of the slot
number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port NIC is
located in slot 1 of your system, the interface names are lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
Note:
In a 1U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from left to right.
In a 3U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from bottom to top.
The following table describes the Two-Port LR/SR Fiber 10-GbE SFP+ card status and LED lights.
LED
Condition
Link
Turns yellow for any link speed.
Activity
Solid green on link.
Blinks green on activity.
LED
Condition
Link/Activity
Solid green on link.
Blinks green on activity.