146 | NIC Status Lights for xx60, xx55, and xx50 Appliances
NICs for SteelHead CX, DX, EX, SteelFusion, and SteelCentral platforms
Four-Port LX Single Mode Fiber Gigabit Ethernet card
This section describes the Four-Port LX Single Mode Fiber GbE card (410-00046-01) status lights.
Figure C-3. Four-Port LX Single Mode Fiber GbE NIC
The interface names for the NICs in the SteelHead Management Console and the CLI are a combination
of the slot number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port
NIC is located in slot 1 of your system, the interface names are lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
Note:
In a 1U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from left to right.
In a 3U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from bottom to top.
The following table describes the Four-Port LX Single Mode Fiber GbE NIC status and LED lights.
Four-Port LX/SX Fiber Gigabit Ethernet SFP card
This section describes the Four-Port LX/SX Fiber GbE SFP card (410-00048-01) status lights. This card is
a standard NIC (without bypass functionality) for use with SteelCentral appliances.
Figure C-4. Four-Port GbE LX/SX Fiber SFP NIC
LED
Condition
Link/Activity
Solid green on link.
Blinks green on activity.
Link/Bypass/Fail-to-Block (disconnect)
Turns off for a normal link.
Solid green in bypass mode.
Solid yellow in disconnect mode.