ZyXEL Communications ZyWall USG 50-H Series, Руководство пользователя

Страница: 549 / 704

Chapter 36 System
ZyWALL USG 50-H User’s Guide
549
The following table describes the labels in this screen.
36.11 Language Screen
Click System > Language to open the following screen. Use this screen to select a display
language for the ZyWALL’s web configurator screens.
Table 209 System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the
Service Control table to access the ZyWALL
using this service.
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Get Community Enter the Get Community , which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows all
requests.
Set Community Enter the Set community , which is the password for incoming Set requests from
the management station. The default is private and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
Service Control This specifies from which computers you can access which ZyWALL zones.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL’s (non-configurable)
default policy. The ZyWALL applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ZyWALL will not have to use the default policy.
Zone This is the zone on the ZyWALL the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
Action This displays whether the computer with the IP address specified above can access
the ZyWALL zone(s) configured in the
Zone field ( Accept ) or not ( Deny ).
Add icon Click the Add icon in the heading row to open a screen where you can add a new
rule. Refer to Table 203 on page 530 for information on the fields.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Add icon in an entry to add a rule below the current entry.
Click the Delete icon to remove an existing rule. A window display asking you to
confirm that you want to delete the rule. Note that subsequent rules move up by one
when you take this action.
Click the
Move to N icon to display a field to type a number for where you want to
put that rule and press [ENTER] to move the rule to the number that you typed.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.