ZyXEL Communications ZyWALL USG 100 Series, Руководство пользователя, Страница: 722 / 1157

Chapter 39 Device HA
ZyWALL USG 100/200 Series User’s Guide
722
A bridge interface’s device HA settings are not retained if you delete the bridge
interface.
Figure 482 Configuration > Device HA > Active-Passive Mode > Edit
The following table describes the labels in this screen.
Table 191 Configuration > Device HA > Active-Passive Mode > Edit
LABEL DESCRIPTION
Enable
Monitored
Interface Select this to have device HA monitor the status of this interface’s
connection.
Interface
Name This identifies the interface.
Note: Do not connect the bridge interfaces on two ZyWALLs without
device HA activated on both. Doing so could cause a
broadcast storm.
Either activate device HA before connecting the bridge interfaces or
disable the bridge interfaces, connect the bridge interfaces, activate
device HA, and finally reactivate the bridge interfaces.
Virtual Router
IP (VRIP) /
Subnet Mask This is the interface’s (static) IP address and subnet mask in the virtual
router. Whichever ZyWALL is currently serving as the master uses this
virtual router IP address and subnet mask. These fields are blank if the
interface is a DHCP client or has no IP settings.
Management
IP Enter the interface’s IP address for management access. You can use
this IP address to access the ZyWALL whether it is the master or a
backup. This management IP address should be in the same subnet as
the interface IP address.
Manage IP
Subnet Mask Enter the subnet mask of the interface’s management IP address.
OK Click OK to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving your changes.