ZyXEL Communications Prestige 792H, Руководство пользователя

Страница: 199 / 437

Prestige 792H User’s Guide
VPN Screens 14-29
Table 14-13 Sample IKE Key Exchange Logs
LOG MESSAGE DESCRIPTION
!! Local / remote IPs of incoming
request conflict with rule <#d> If the security gateway is “0.0.0.0”, the Prestige will
use the peer’s “Local Addr” as its “Remote Addr”. If
this IP (range) conflicts with a previously configured
rule then the connection is not allowed.
!! Invalid IP <IP start>/<IP end> The peer’s “Local IP Addr” range is invalid.
!! Remote IP <IP start> / <IP end>
conflicts
If the security gateway is “0.0.0.0”, the Prestige will
use the peer’s “Local Addr” as its “Remote Addr”. If a
peer’s “Local Addr” range conflicts with other
connections, then the Prestige will not accept VPN
connection requests from this peer.
!! Active connection allowed
exceeded The Prestige limits the number of simultaneous Phase
2 SA negotiations. The IKE key exchange process fails
if this limit is exceeded.
!! IKE Packet Retransmit The Prestige did not receive a response from the peer
and so retransmits the last packet sent.
!! Failed to send IKE Packet The Prestige cannot send IKE packets due to a
network error.
!! Too many errors! Deleting SA The Prestige deletes an SA when too many errors
occur.
The following table shows sample log messages during packet transmission.
Table 14-14 Sample IPSec Logs During Packet Transmission
LOG MESSAGE DESCRIPTION
!! WAN IP changed to <IP> If the Prestige’s WAN IP changes, all configured “My IP Addr” are
changed to b “0.0.0.0”.. If this field is configured as 0.0.0.0, then the
Prestige will use the current Prestige WAN IP address (static or
dynamic) to set up the VPN tunnel.
!! Cannot find Phase 2 SA The Prestige cannot find a phase 2 SA that corresponds with the
SPI of an inbound packet (from the peer); the packet is dropped.
!! Discard REPLAY packet If the Prestige receives a packet with the wrong sequence number it
will discard it.