ZyXEL Communications PRESTIGE 153, Руководство пользователя, Страница: 39 / 186

Prestige 153/153X WAN Bridge/Routers
2-5 Chapter 2 Hardware Installation & Initial Setup
This section outlines how to connect your Prestige 153/153X to the LAN and the WANs. Refer to
Figure 1-2 to identify all of the ports on your device. Then see Figure 2-1 when you attempt to
make the various connections.
Follow these steps designed to guide you through a quick and correct installation of your Prestige
153/153X.
A Warning On Connection Cables
The SMT RS-232 cable, WAN-3 modem line, and Ethernet cable are very similar to each other. It
is important that you use the correct cable for each connection; otherwise, your Prestige could be
damaged.
Step 1.
Connect your Computer and your Prestige
For the initial setup and configuration of your Prestige 153/153X, you must use RS-232 and
communications software.
After your Prestige has been successfully installed, you can modify the configuration through a
remote Telnet connection. See
Chapter 12 - Telnet Configuration and Capabilities for detailed
instructions on using Telnet to configure your Prestige 153/153X.
Note on Connecting the RS-232 Cable to your Prestige
One RJ45 to RS-232 female adapter cable is included in your package. To make a RS-232
connection, first connect the RJ45 end of the cable to the CONSOLE port on the back panel of the
Prestige. Connect the other end to the RS-232 cable attached to the serial port (COM1, COM2, or
any other COM port) of your computer.
Step 2.
Connect WAN Ports to your Prestige
The Prestige 153/153X has three WAN ports which can be connected to a Dial-up modem, a
Leased Line modem, or ISDN TA (Terminal Adapter). WAN1 and WAN2 use DB-25 connectors
(female). WAN3 uses a RJ-45 connector. A cable is provided to convert RJ-45 to DB-25.