ZyXEL Communications P-662HW-63, Руководство пользователя

Страница: 216 / 561

Prestige 662HW Series User’s Guide
Chapter 18 Introduction to IPSec 216
NAT is incompatible with the AH protocol in both Transport and Tunnel mode. An IPSec
VPN using the AH protocol digitally signs the outbound packet, both data payload and
headers, with a hash value appended to the packet. When using AH protocol, packet contents
(the data payload) are not encrypted.
A NAT device in between the IPSec endpoints will rewrite either the source or destination
address with one of its own choosing. The VPN device at the receiving end will verify the
integrity of the incoming packet by computing its own hash value, and complain that the hash
value appended to the received packet doesn't match. The VPN device at the receiving end
doesn't know about the NAT in the middle, so it assumes that the data has been maliciously
altered.
IPSec using ESP in Tunnel mode encapsulates the entire original packet (including headers)
in a new IP packet. The new IP packet's source address is the outbound address of the sending
VPN gateway, and its destination address is the inbound address of the VPN device at the
receiving end. When using
ESP protocol with authentication, the packet contents (in this case,
the entire original packet) are encrypted. The encrypted contents, but not the new headers, are
signed with a hash value appended to the packet.
Tunnel mode ESP with authentication is compatible with NAT because integrity checks are
performed over the combination of the "original header plus original payload," which is
unchanged by a NAT device.
Transport mode ESP with authentication is not compatible with NAT, although NAT
traversal provides a way to use Transport mode ESP when there is a NAT router between the
IPSec endpoints (see the NAT Traversal section for details).
Table 65 VPN and NAT
SECURITY PROTOCOL MODE NAT
AH Transport N
AH Tunnel N
ESP Transport N
ESP Tunnel Y