ZyXEL Confidential
27/34
exit
exit smt menu
ether config
display LAN configuration information
ether driver cnt disp <name>
display ether driver counters
ether driver cnt clear <name>
clear ether driver counters
ether driver iface <ch_name> <num>
send driver iface
ether driver mac <ch_name> <mac_addr>
Set LAN Mac address
ether driver reg <ch_name>
display LAN hardware related registers
ether driver rxmod <ch_name> <mode>
set LAN receive mode.
mode: 1: turn off receiving
2: receive only packets of this interface
3: mode 2+ broadcast
5: mode 2 + multicast
6: all packets
ether driver status <ch_name>
see LAN status
ether driver init <ch_name>
initialize LAN
ether driver config [0|1=auto|normal]
[0|1=10|100] [0|1=HD|FD] <ch-name>
ether version
see ethernet device type
wan adsl chandata
ADSL channel data, line rate
wan adsl close
Close ADSL line
wan adsl linedata near
Show ADSL near end noise margin
wan adsl linedata far
Show ADSL far end noise margin
wan adsl open
Open ADSL line
wan adsl opencmd Glite
Open ADSL line with specific standard
wan adsl opencmd T1.413
wan adsl opencmd Gdmt
wan adsl opencmd multimode
wan adsl opencmd adsl2
wan adsl opencmd adsl2+
wan adsl opencmd adsl2_delt
wan adsl opencmd adsl2+_delt
wan adsl opencmd readsl2
wan adsl opencmd readsl2_delt
wan adsl opmode
Show the operational mode
wan adsl rateadap [on|off]
Turn on/off rate adaptive mechanism
wan adsl perfdata
Show performance information,CRC,FEC, error seconds..
wan adsl reset
Reset ADSL modem, and must reload the modem code again
wan adsl Status
ADSL status (ex: up, down or wait for init)
wan adsl errorsecond shutdown
wan adsl targetnoise [value]
Adjust target noise offset
wan adsl driver
wan adsl vchunt Add <remoteNodeIndex>
<vpi> <vci> <service bit(hex)>
Add a entry to hunting pool
<remote node> : input the remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it’s a hex value, bit0:PPPoE/VC (1),
bit1:PPPoE/LLC (2) , bit2:PPPoA/VC (4), bit3:PPPoA/LLC
(8), bit4:Enet/VC (16), bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC and Enet/LLC then the
service bits will be 2+32 = 34 (decimal) = 22 (hex), you must
