ZyXEL Confidential
13/34
1. Configure device and make it can access Internet.
2. Enable MBM LAN and WLAN interfaces, set a large Bandwidth. (e.g.100000)
3. LAN PC1 connects to device with wire, and can ping domain out.
4. PC2 connects to device with wireless, and ping domain out.
5. LAN PC1 cannot ping domain out anymore, but can ping ip out.
Modification in 3.40(APR.2)b1 | 09/18/2007
1.
[Bug Fix]
[Symptom]: Inactive wireless, then reboot device, device will hang-up.
[Condition]:1.Inactive wireless.
2. Reboot device, System initial can't be finished, device will hang-up.
[Note]: The issue happens only if 2230S has quality issue. It’s only a workround
solution.
2.
[Bug Fix]
[Symptom]: When triple play enabled, set a static WAN IP, LAN PC try to access
WAN site behind a router, the TCP 3 way handshake can not be successful.
[Condition]:
1. Set a static WAN IP in PVC1 and configure it to connect to Internet successfully.
2. enable triple play.
3. LAN pc try to access a website in Internet.
4. web page can not be opened.
3.
[Bug Fix]
[Symptom]: After adsl test on HTP program, 3085 AFE current will increase to
300mA, higher than normal value 100mA , and it causes AFE chipset failure and impact
the performance of longer loop .
[Condition]: N/A
4.
[FEATURE CHANGE]
[Symptom]: (1) Remove the hardware version information which is shown together
with modem code version by C/I command “wan adsl fwversion”, SMT 24.2.1 or GUI. For
hardware version is the identification of CPU type, such information may confuse
customers in some case.
(2)Change the behavior of C/I command “sys typeOfCPU” to show hardware
version.
5.
[Bug Fix]
[Symptom]: When we input “sys cpu disp” it will show CPU type information. This
information should be shown when we input “sys cpuType”.
[Condition]: Input CI command “sys cpu disp” through console or telnet connection. It
will show CPU type. The correct information shown should be CPU loading.
6.
[Bug Fix]
[Symptom]: Tone assignment shown in CO and CPE side are different. Every byte
shown is converse.
[Condition]:
1).Connect CPE to IES5000.
2).Use command "wan adsl line n/f" in CPE side and use command "show line
portnumber" in IES5000 side to show tone assignment.
3).Compare the tone assignment value.For example, tone 6 and 7 are 07 from
