ZyXEL Communications AAM1212, Руководство пользователя

Страница: 148 / 288

AAM1212 User’s Guide
Chapter 19 Access Control 147
The following table describes the labels in this screen.
19.3.5 Setting Up the Administrator Login Account
Click Advanced Application and Access Control from the navigation panel and then Logins
from the Access Control screen to open the following screen.
Note: It is highly recommended that you change the default administrator password
("1234").
Figure 75 Access Control: Logins
Table 46 Access Control: SNMP
LABEL DESCRIPTION
Return Click Return to go back to the previous screen.
Get Community Enter the get community, which is the password for the incoming Get- and
GetNext- requests from the management station. You can use up to 31 ASCII
characters; spaces are not allowed.
Set Community Enter the set community, which is the password for incoming Set- requests from
the management station. You can use up to 31 ASCII characters; spaces are not
allowed.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
manager. You can use up to 31 ASCII characters; spaces are not allowed.
Trap Destination Enter the IP address of a station to send your SNMP traps to.
Port Enter the port number upon which the station listens for SNMP traps.
Trusted Host A “trusted host” is a computer that is allowed to use SNMP with the AAM.
0.0.0.0 allows any computer to use SNMP to access the AAM.
Specify an IP address to allow only the computer with that IP address to use SNMP
to access the AAM.
Apply Click Apply to save your changes to the AAM’s volatile memory. The AAM loses
these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.