Zy Safe Prime-Care L13, Инструкция по эксплуатации

Страница: 23 / 84

23
User guide - GB
D.
Reducer cushion
(if fitted on this model)
E. Harness crotch strap (used only for Group 1)
F.
Harness adjustment strap
(x2 - used only for Group 1)
G. ISOFIX/EASYFIX adjustment handle
H. Lifting armrest (x2)
I.
ISOFIX/EASYFIX connector
(x2)
J. Adjuster (x2 - used only for Group 1)
K.
Safety pads
(x2 - used only for Group 1)
L. Shell + cover
M. Top Tether strap (used only for Group 1)
N.
ISOFIX/EASYFIX connector release button
(x2)
Installing the car seat with the harness
Group 1, 9 to 18 kg (approx. 9 months to 4 years)
WARNING
• This is an ISOFIX SAFETY RESTRAINT DEVICE FOR CHILDREN. It is compliant with Regulation
44/04 for use in a vehicle fitted with an
ISOFIX
anchoring system.
• It may be used in vehicles fitted with seats approved as universal ISOFIX positions (refer to
your car manual), according to the category and size of the child safety restraint.
• The mass group and the ISOFIX size class for which this product is suitable are: B1 / 9-18
kg .
If in doubt, please contact the car seat manufacturer or the retailer.
Adjusting the harness
Make sure that the harness of your car seat is adjusted to the height of your child before
installing it in your vehicle. The shoulder harnesses can be adjusted to 3 different heights and
must pass through the holes closest to your child’s shoulders. If your child’s shoulders are
between two levels always use the higher of the two. To adjust the height of the harnesses,
remove the upper section of one of the straps by pivoting the metal anchor located behind
the headrest (2) , and then pulling the end of the strap through the slots of the shell and the
cover
(3)
. Feed the end of the harness strap through the same slots at the desired height,
both in the cover and the shell (4) and reattach it behind the backrest (5) . Make sure that the
metal anchor is correctly positioned and that the end of the strap is not twisted. Repeat the
procedure with the second strap.
Installing the car seat and placing the child in the vehicle
This car seat must only be fitted on the rear seat of a vehicle equipped with ISOFIX fas-
tenings and a Top Tether anchor (universal ISOFIX). Please refer to your car manual.
WARNING!
Your ISOFIX Group 1 car seat MUST be fitted using the Top Tether strap provided!
Your child’s safety cannot be guaranteed if you install your ISOFIX Group 1 car seat without
the Top Tether strap.
Put the headrest of the car seat at its lowest position. Fold the Top Tether strap over the back of