Zwilling EcoQuick II, Руководство по эксплуатации, Страница: 27 / 34

20 21
6 Troubleshooting 5 After use
EN
3. Rinse the lid under running water. Take particular
care to clean the bottom of the lid thoroughly
and to remove any residue of food in the area of
the valves (see fi g. 20).
4. Push the pressure regulator down and turn it to
position . Lift and remove the pressure regulator
(see fi g. 21). Rinse the pressure regulator under
running water. Also remove the silicone spring
and clean separately.
5. Dry the cleaned components.
6. Reinsert the pressure regulator into the lid. Turn
the pressure regulator clockwise beyond the
point at which there is a noticeable resistance.
7. Place the lid together with the sealing ring
upside down on the pot. This reduces the wear
on the sealing ring (see fi g. 22).
8. Once the pressure cooker has cooled down,
been cleaned and dried, store it:
¡
In a cool, dry storage space
¡
So that it is inaccessible to children
¡
Away from sharp or pointed objects
¡
Do not stack any objects on the device.
Abb. 20: Cleaning the lid
Abb. 21: Detaching the pressure
regulator
Abb. 22: Storage
6 6 Troubleshooting
6.1 Resolving faults yourself
WARNING!
Faults may result in unsafe operation.
¡
If the pressure cooker is damaged, do not use it all. If the pressure cooker
shows obvious signs of malfunction during operation, immediately turn off the
energy supply to the hob. Allow the pressure cooker to cool down and then
remove it from the hob.
¡
Do not try to repair the pressure cooker yourself.
Fault Possible cause(s) Possible solution(s)
Lid can only
be closed with
diffi culty. Friction between seal-
ing ring and pot is too
great. Moisten the edge of the pot with a
small amount of cooking oil.
Pot is deformed. Contact Zwilling customer service.
Opening slide
can only be
operated with
diffi culty. Locking mechanism on
the lid shaft handle is
dirty. Clean the lid shaft handle thoroughly
under running water.
Locking mechanism is
damaged. Replace the lid shaft handle.
Despite a long
heating phase,
pressure does
not build-up in
the pot. Minimum fi lling quanti-
ty was not observed. Fill at least 1/3 of the pot with water.
Energy supply is too
low. Set the energy level of the hob
higher.
Make sure that the diameter of the
hob is large enough.
Sealing ring is incor-
rectly inserted. Insert the sealing ring fi rmly into the
edge of the lid.
Sealing ring is dam-
aged. Replace the sealing ring.
Steam escapes
at the edge of
the lid. Sealing ring does not
seal properly. Insert the sealing ring fi rmly into the
edge of the lid.
Replace the sealing ring if it is dam-
aged.
0102075Y1_BA_ZWILLING_EcoQuick_II_EN_10-17.indd 20-21 24.10.17 17:32