FV722 Rev. A 07/23/20
Page 6
1. Remove vandal-resistant cover with allen wrench from control
stop (if present) and turn control stop clockwise to turn off the
water supply.
2. Press and hold the manual override button for 3 seconds to
release any residual pressure.
3. Use a 5/64” allen wrench to remove the two cap screws from
the sensor cap and remove the sensor cap. Disconnect black
solenoid plug shown below.
Connected Sensor Cap Retrofit Installation Instructions
4. Remove the 4 sockets screws shown using a M3 allen wrench
and discard the screws
Solenoid
connecting
wire
Right-hand Orientation
Left-hand Orientation
Remove
Remove
Remove
Remove
