FV722 Rev. A 07/23/20
Page 7
5. Note socket screw pockets in the ring insert and place over
remaining 2 socket screws See Figure below.
6. Ensure ring insert set screws align with valve body holes shown in Figure below. Hand start the 4 new sockets screws(included) into
the ring insert. Tighten screws in the torque sequence shown on Figure on Tightening squence.
Then, Follow steps 2 & 3 from Battery installation Instructions Section.
1
3
4
2
Tightening Sequence
7. Align set screw hole in sensor cap with key way in ring insert and place sensor cap on valve body.
Rotate sensor cap counter clockwise until the set screw is visible in the sensor cap hole and the sensor is facing forward. Using
the 3/32” allen wrench(provided) rotate the set screw clockwise to secure the cap.
