FV669 Rev. G 06/22/22
Page 5
Battery Installation - STEP 4
STEP 4.1
Use the 3/32” Allen Wrench to loosen the internal set screw
counter-clockwise until it stops. Screw will retract into the shell.
STEP 4.3
Flip the valve cap upside down on a flat, soft surface. Loosen the
knurled screw by hand to remove the battery cap. Use flat head
screwdriver to loosen knurled screw if necessary.
STEP 4.5
Insert four batteries (supplied) into battery housing and ensure the
batteries are inserted in the correct orientation. Use AA Lithium
Batteries or AA Alkaline batteries, but do not mix Lithium with Alkaline.
STEP 4.2
Remove the valve cap by turning it counter-clockwise and lifting
gently. Disconnect the wire harness before fully removing valve
cap.
STEP 4.4
Remove the battery cap from the battery housing.
STEP 4.6
See notes below and reverse steps 4.1 - 4.4 to reinstall battery
cap and valve cap onto valve body. Then, turn control stop back
on by turning counter-clockwise using a flat head screw driver.
Note: Knurled screw on
battery cap should only
tighten by hand.
Note: During reassemble,
connectors between valve
cap and valve body should
be placed in the empty
place as shown below.
Figure 15B
318613-001
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15A
