ENG
www.zraysports.com
www.zraysports.com
ENG
2
3
DO NOT RETURN THIS PRODUCT TO A STORE
INTRODUCTION
PRODUCT DESCRIPTION
INSTALLATION
Thank you for purchasing your ZRAY DRIFT Inflatable 2-person Kayak. Please follow
these instructions for correct assembly. Failure to follow these instructions may result
in drowning or serious injury.
The ZRAY DRIFT inflatable kayak is designed for short trips over calm lakes, seas or
rivers (less than 3 hours), and is suitable for 1 - 2 adults.
• This is not a life saving device. Use only under competent adult supervision. When
not in use do not leave unattended near the water.
• Read the owner’s manual thoroughly, ensure your understanding and follow the
instructions. Keep this manual for future reference.
The ZRAY DRIFT inflatable kayak is equipped with two sets of paddles, two
inflatable seats, double action high-pressure inflating pump, backpack, fin and a
repair kit.
The ZRAY DRIFT kayak has 3 air chambers comprising two side air chambers and a
bottom air chamber. The two seats are also inflatable.
Hull inflation:
1. Open and spread the kayak so it is flat. Check to make sure that the air valves and
②
are in the ‘inflate’ position and the two automatic bottom drain plugs are closed.
2. First, inflate air chamber
①
and
②
by 10% - 20% and be sure that both sides of the
air chambers are evenly inflated. (Figure 1)
3. Ensure the floor is smooth and flat at the bow before inflating the sides.
4. Inflate air chambers
①
and
②
by 100% (8PSI), respectively. Make sure that both
sides are inflated evenly.
5. Inflate air chamber
③
by 100% (8PSI).
6. If both sides of the hull are not even, adjust the air volume of air chamber
①
and
②
.
Hull installation:
1. Inflate seats until your hands feel that the seats have been inflated by 100%. Be sure
they are not over-inflated or they could burst.
2. Install seats. Note, the rear seat is attached to the D rings nearest the stern so that
the seat is as far back as possible. The second set of straps will sit unsecured behind
the seat. (See figure 2)
3. Install footrests into the loops on the floor of the kayak.
Length 168”/426cm
Width 32”/81cm
Number of air chambers 4
Maximum pressure
8 PSI
Load capacity 485bls/220 kg
Maximum number of boaters
2
Displacement
507lbs/230 kg
For any questions, queries or problems please contact us at:
Toll free: Monday – Friday 9am – 4pm PST – (866) 946-3002
Or via email: [email protected]
WARNING
• Review the Government’s Boating Safety Guidelines to ensure you have the relevant
equipment and most up to date regulations.
http://www.tc.gc.ca/media/documents/marinesafety/TP-511e.pdf
• Do not exceed the maximum load capacity. Overloading can be dangerous and
voids the warranty.
• For use only in lakes, rivers and calm seas. Do not use for white water rafting.
• Distribute the weight of paddlers and accessories evenly through the boat.
• All persons must wear a PFD (Personal Floatation Jacket)
• Ensure all persons are aware of the regulations and safety instructions before use.
Deflate
lower position
Inflate
higher position
