Note
Do no
t open the appliance lid during baking. The bread can collapse.
Tip:
After 5 minutes of kneading, check the consistency of the dough. It should be a soft,
sticky lump. If it is too dry, a
dd some liquid to it. If it is too moist, add
some flour (1/2 to 1 teaspoon one or more times, as needed).
Ending a program
When the baking process has been completed, ten acoustic signals are issued and the display
indicates 0:00. At the end of the program the appliance automatically changes to a warming
mode for up
to 60 minutes. In
this mode, warm air circulates inside the appliance. You can
prematurely terminate the warming function by keepi
ng the Start/Stop button pressed until two
acousitc signals are heard. The “keep warm” phase does not apply to program 4,7,10 or 13.
Warning
Before opening the appliance lid, pull the power plug out of the wall socket. When not in use,
the appliance should never be plugged in!
Taking out the bread
When taking out the baking pan, always use pot holders or oven gloves. Hold the baking pan
tilted over a grid and shake lightly until the bread slides out of the baking pan. If the bread
does not slip off the kneading paddles, carefully remove the kneading paddles using the
enclosed kneading paddle remover.
Note
Do not use any metal objects that may lead to scratches on the non-stick coating. After
removing the bread, immediately rinse the baking pan with warm water. This prevents the
kneading paddles from sticking to the driving shaft.
Tip:
If you remove the kneading paddles after the last kneading of the dough, the bread will
remain intact when you remove it from the baking pan.
• Briefly press the Start/Stop button, to interrupt the baking process or pull the power plug out
of the wall socket.
• Open the appliance lid and take out the baking pan. You can take the dough out with floured
hands and remove the kneading paddles.
• Replace the dough and close the appliance lid.
• Push the plug back into the wall socket and press the Start/Stop button. The baking program
is continued. Let the bread cool for 15-30 minutes before eating. Before cutting bread, make
sure that no kneading paddle is still in the baking pan.
Warning
Do not attempt to start operating the bread maker, before it has either cooled down or warmed
up.
If the display shows “HHH” after the program has been started, it means that the
temperature inside of bread pan is too high. You should stop the program and unplugged the
power outlet immediately. Then open the lid and let the machine cool down completely before
using again . If the display shows “EE0” after you have pressed Start/Stop
button,Switch off
the main switch and disconnect the mains plug, then insert the mains plug again and switch on
