18
heat source or nearby tree branches or brush (especially on windy
days).
DO NOT install the camera behind the glass window as that is not
possible to sense any motion. Avoid the camera toward to glass
object.
8.3. SWITCHING ON THE CAMERA
Once you switch to the
ON
mode, the motion indicator LED (blue)
will blink for about 15 seconds. This gives you time to close and
lock the front cover of the camera and then walk away. During
this time, the motion indicator LED will blink blue continuously.
After it stops blinking, the PIR is active, and any motion that is
detected by it will trigger the capture of photos or videos as
programmed in the
SET
Menu. Be sure you have read the
descriptions of the Picture No, Video Length, Interval and Sensor
Level parameters. Please note, the PIR is strongly sensitive to
ambient temperature. The greater the temperature difference
between the environment and your subject, the farther the possible
sensing distance. The average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the
following:
Are the batteries inserted with correct polarity and is their
power level sufficient?
Does the SD card have sufficient available space and is its
write-protection (lock) switch off?
Is the Power switch in the
ON
position? (do not leave it in
SET).
9. REVIEW PHOTOS OR VIDEOS
After you have setup, mounted and activated your CAMERA, you
will of course be eager to return later and review the images it has
captured for you. The camera stores photos and videos in the
folder \DCIM\100MEDIA in the SD card. Photos are saved with
