10
doing so.
NOTES: When the power switch is set to ON position,
the camera requires 30-60 seconds for PIR Sensor warming up,
and then begin working (sensing motion event).
6.3.
SET MODE
In the
SET
mode you can check and change the settings of the
camera with the help of its built-in LCD. These settings, found in
the menu by pressing
MENU
key, let you change the photo or
video resolution, interval between photos, switch the time imprint
on, etc.
(See more in Section 7 ADVANCED SETTINGS)
Moving the power switch to the
SET
position will turn on the
LCD display, and you will see an information screen that shows
how many images have been taken, the battery level, camera or
video mode, etc.
Shortcut Keys/Functions
As mentioned earlier in "Parts & Controls", the keypads have
secondary, "shortcut" functions when the camera is switched to
SET
mode (but the key has not been pressed):
Press the
UP
key to quickly set the camera to shoot video clips.
Press the
DOWN
key to quickly set the camera to take still
photos.
Press the
RIGHT
key to manually trigger the shutter. This is
useful for testing the camera-make sure you are in
SET
mode,
press the
RIGHT
key, and a few seconds later a photo or video
(depending on how the camera was set) will be saved to the SD
card. The "number of images taken" counter on the top right of
the LCD will increase by one. If the display indicates "Card
Protected" when you press the
RIGHT
key. switch the camera
OFF
, remove the SD card and slide its protect switch off.
Press the
OK
key to playback, see more in the next section.
6.4.
PLAYBACK ON THE CAMERA SCREEN
Once you have some photos or videos in the SD card, you can
