Group 2 for control command communication to associated Z-Wave devices in the network.
Use parameters 2, 3, 5, and 8 to configure this group’s settings. Supported command classes:
BASIC_SET
Group 3 for notifications to Z-Wave devices associated in this group. Supported command
classes:
NOTIFICATION_REPORT_V4
Group 4 for notifications to Z-Wave devices associated in this group. Supported command
classes:
SENSOR_BINARY_REPORT_V2
Please refer to your controller's user guide for advanced programming instructions as they
are a little different for every software.
ADVANCED SETTINGS
If your controller’s software allows for advanced configuration and parameter adjustment,
you will be able to change and save the settings below and customize the Mini Sensor’s
performance to serve your needs.
Motion Detection
Parameter 4: Use this parameter to enable and disable motion detection on your Mini Sensor.
Values: 0
–
Motion detection disabled. 255 –
Motion detection enabled (default).
Size: 1 byte dec.
Motion Sensitivity
Parameter 1: Choose the right motion sensitivity for your environment and lifestyle. Adjust
detection just right by choosing a value from 8 to 255, where 8 stands for high sensitivity level
(detection of the smallest movement) and 255 stands for very low sensitivity level.
Values: 8
–
255. 12 –
default setting.
Size: 1 byte dec.
Motion Trigger Interval
Parameter 6: Adjust the time when motion is reported again after initial trigger. The number
entered as the value corresponds to the number of seconds. So if 8 is entered by default, the
Mini Sensor will report motion for 8 seconds after it first detects movement. The value set for
this parameter can NOT be greater than value set in parameter 2.
Values: 1
–
8 (seconds). 8 (seconds) –
default setting.
Size: 1 byte dec.
NOTE: Small interval will increase activity and affect battery life.
Trigger ON Duration
Parameter 2: Set the duration you want the associated device to stay ON for after being
triggered by the sensor before it automatically turns OFF. The number entered as the value
corresponds to the number of seconds. So if 30 is entered by default, the associated device
will stay ON for 30 seconds after the Mini Sensor reports status change (BASIC_SET
command) and triggers the device, it will then turn off automatically. It’s an easy and quick
way to set up a motion-based lighting event. If you change this setting to 300, the associated
Z-Wave light fixture will stay ON for 5 minutes after motion has been detected by the Mini
Sensor. The value set for this parameter needs to be greater than value set in parameter 6.
