
Updating
the
MRS-1044
to
Version
1.2
3.
Use the screws removed in step 1 to fasten the SIB-01.
The SIB-01 works only in the MRS-1044 if the system is Version
1.2 and later. If your MRS-1044 is Version 1.0, you must update
your system as described on the next page.
NOTE
Correct
Incorrect
Installing
the
SIB-01
Updating the MRS-1044 to Version 1.2
In order to use the SIB-01, the MRS-1044 system must be updated to
Version 1.2. Perform this update using the "Version Update" CD-ROM
supplied with the SIB-01.
• To perform the update, a SCSI compatible CD-R/CD-RW drive or CD-
ROM drive is required. If you do not have a suitable drive, please
consult your dealer or contact ZOOM Corporation.
• The SIB-01 comes with two CD-ROMs: a "Version Update Disc"
(green label) for updating the system and a "Recovery Disc" (red label)
for restoring the hard disk of the MRS-1044 to the factory default
condition. Be careful not to mix up these discs.
If you use the "Recovery Disc" and perform the steps described
below, all user projects will be deleted.
1.
Connect the SCSI connector on the MRS-1044 (with SIB-01
installed) to the SCSI connector of the CD-R/CD-RW (CD-
ROM) drive, using a SCSI cable.
Before performing this step, make sure that power to both components
is turned off. For details regarding the SCSI connection, refer to page
8.
2.
Turn power to the CD-R/CD-RW (CD-ROM) drive on, insert the
"Version Update Disc" (green label), and then turn power to
the MRS-1044 on.
Green label
Red label
Version Update Disc
Only updates the
system.
Projects created by
user are retained.
Recovery Disc
!
Caution
!
Restores hard disk to factory default
condition. System will be Version 1.2.
All projects created by
user will be deleted.
NOTE
5
ZOOM SIB-01
4
ZOOM SIB-01