15
Step 7: Install the Camera to the Surface
Before installing the camera to the installation place, the camera must have the following
preparations completed.
①
Cable withdrawal was completed.
②
Waterproofing of the cable and the Cable Hole and so on were completed.
③
Memory card installation was completed.
1.
According to the above described Steps 1 to 4,
complete the above ①~③.
2.
Attach the camera to the installation surface using
the four Installation Screw Holes on the Installation
Plate. (Right figure, red circle)
※
In order to prevent a possibility of invasion of rain, it is
recommended to install at the angle where the Cable
Hole faces downward.
※
Do not loosen or remove the Camera Fixing Screw (right figure, 3 yellow squares) that fixes
the camera to the Installation Plate.
※
Please use screws for installation that match the material of the installation place.
※
Because the camera is heavy, fixing should be based on the bolt & net tightening.
Disclaimer: The manufacturer will not be responsible for camera damage caused by
improper installations or the misuse of equipment for installation.
The basic installation of the camera is completed with the above.
Issues which are not mentioned up to this point, such as the connections of
external power supply, audio input / output, digital input / output and the
installation of memory card will be explained in the subsequent chapters. Please
refer as necessary.
For the connection to the network, refer to the page 23 or later.
