ZOOM GFX-3
6
Getting Ready to Play
Inserting the batteries
To use the GFX-3 on battery power, insert
batteries as shown below.
1.
Turn the unit over and open the
battery compartment cover. (Push
the tab to unlock and then raise the
cover.)
2.
Insert the batteries with correct (+)
(-) polarity into the battery
compartment.
3.
Close the battery compartment
cover. (Make sure that the tab is
properly engaged.)
N
OTE
• When not using the unit for an extended
period, remove the batteries to prevent the
possibility of damage by leaking battery
fluid.
• If the indication "bt" alternates on the
display with the regular indication, the
batteries are almost exhausted. Replace
the batteries as soon as possible with fresh
ones.
Getting connected
1.
Make sure that the amplifier and
the GFX-3 are switched off.
Turn the volume at the amplifier to minimum.
2.
To power the unit from the AC
adapter, insert the small plug of the
adapter cable into the [DC IN] jack
on the GFX-3. Then plug the
adapter into an AC outlet.
3.
Connect the guitar to the [INPUT]
jack of the GFX-3, using a mono
cable.
4.
Connect the [OUTPUT/PHONES]
jack of the GFX-3 to the guitar amp,
using the cable.
To monitor the sound with headphones, plug the
phones into the [OUTPUT/PHONES] jack.
5.
Turn power on in the following
order: GFX-3
→
amplifier.
OPEN
Battery
compartment
cover
GFX-3 bottom
Tab
Four IEC R6 (size AA)
batteries
Battery
compartment cover
Battery polarity
alternates
for each slot.
BbT
En-GFX3.book 6 ページ ２００４年１１月８日 月曜日 午後４時３０分
