ZOOM GFX-3
17
Effect modules
Effect types
MOD
CHORUS
FLANGE
PHASE
WAH
TREM/PAN
VIBE
PITCH
SFX
SLOW-A
RING
PDL-PIT
DRIVE
FDR
MS
BG
CLEAN
HI-GAIN
ZOOM
OVER DRIVE
DIST
FUZZ
METAL
ACOUSTIC
REV/DLY
HALL
ROOM
SPRING
MN-DLY
PP-DLY
ECHO
PP-ECHO
REVERSE
DLY+HALL
DLY+ROOM
DLY+SPRING
COMP/ISO
COMP
ISOLATOR
ZNR
ZNR
D GATE
EQUALIZER
CABINET
BOX
Z BOX
BR CMB
CMB
CMB+EV
STK
STK+EV
Effect Types and Parameters
In this section, all effect types and parameters of the modules in the GFX-3 are explained. As shown in the
illustration, the GFX-3 has eight effect modules which can be thought of as being connected in series. It is
possible to use all effect modules together, or to switch individual modules on and off. Nearly all modules
incorporate several effect types, of which one can be selected at a time.
The effect types and parameters that can be used in each module are listed below. The pedal symbol (
)
indicates that the parameter can be assigned to the expression pedal in real time (
→
p. 15).
◆
ZNR/[TOTAL] module
This module serves for adjusting ZNR (ZOOM Noise Reduction), patch level, and other parameters that are common to
all patches.
◆
COMP/ISO (Compressor/Isolator) module
The compressor serves to reduce excessive signal levels. The isolator allows cutting or emphasizing a particular band.
Parameter 1
ZNR/D GATE
Parameter 2
PATCH LEVEL
oF, Z1 – Z8, G1 – G8
1 – 30
Adjusts ZNR/noise gate sensitivity. With the Z1 - Z8 settings, ZNR is
enabled. With the G1 - G8 settings, noise gate is enabled. Set the value
for maximum noise reduction (higher settings) without producing
unnatural sound cutoff.
Adjusts the final patch output level.
Parameter 3
MASTER LEVEL
Parameter 4
ENERGIZE
0 – 30
oF, 1 – 30
Adjusts the master level for all patches.
Controls the Energizer setting that applies to all patches. Lower values
result in stronger emphasis on treble, and higher values result in
stronger emphasis on bass. The "oF" setting disables the Energizer.
Parameter 1
COMP/ISO
Parameter 2
ATTACK/HIGH
CO, IS
ATTACK (CO)
HIGH (IS)
FS, SL
oF, -12 – 12
Select the effect by choosing CO (Compressor) or IS (Isolator). The
effect of parameters 2 - 4 differs, depending on which setting is chosen
here.
The time lag between signal input
and start of compressor action can
be set to FS (FAST) or SL
(SLOW).
Adjusts high-range mix.
En-GFX3.book 17 ページ ２００４年１１月８日 月曜日 午後４時３０分