5
ZOOM 607
BASS
Operating the Unit on Battery Power
Basic
T
erms
/
Operating
the
Unit
on
Battery
Power
patch number. A1 selects patch 1 in bank A, and F4 selects patch 4 in
bank F.
■
Play mode/edit mode
These terms refer to the operation state of the 607. The mode is
selected with the PLAY/EDIT selector. In play mode, you can select
the effects for playing, and in edit mode, you can change the effect
settings.
4
ZOOM 607
BASS
Basic Terms
Basic
T
erms
This section explains some important terms that you will find in this
manual.
■
Effect module
As shown in the illustration below, the effect sound of the 607 is
created by routing the signal through a series of different effects. Each
of these effects is called an effect module.
In addition to effect modules such as DRIVE (distortion),
MOD/PITCH (modulation), or DLY/REV (delay and reverb), you can
also use the ZNR (Zoom Noise Reduction) and amp simulator
simultaneously. Parameters such as effect intensity can be adjusted for
each module, and modules can be switched on and off as needed.
■
Effect type
Each effect module of the 607 contains a variety of effects in the same
general family. These are called effect types, and you can select one of
these at a time. For example, the MOD/PITCH module comprises the
effect types chorus, flanger, pitch shifter, etc.
■
Effect parameter
Each effect module has various parameters that control how the effect
operates. By adjusting the parameters for each module, you have a
considerable amount of control over the final sound.
■
Patch
In the 607, effects are stored and called up in patches. A patch contains
information about module on/off settings, selected effect types, and
effect parameter settings. The 607 can store 42 patches in its internal
memory.
■
Bank
A combination of 6 patches is called a bank. The 607 has a total of 7
banks which are labelled A through G. The patches in each bank are
numbered 1 through 6. To select a patch, you specify the bank and the
Bottom of 607
Latch
Four IEC R6 (size AA)
batteries
Battery
compartment cover
1.
Turn the unit over, push the latch
of the battery compartment
cover, and lift the cover up.
3.
Close the battery compartment cover.
Make sure that the latch snaps shut.
2.
Insert four fresh IEC R6 (size AA)
batteries into the battery compartment.
All four batteries must face in the same
direction.
NOTE
• When a dot (.) flashes on the display, the batteries are almost
exhausted. Replace them as soon as possible.
• When not using the 607, you should disconnect the cable plugged
into the INPUT jack, to prevent draining the batteries.
COMP
WAH
AMP
ZNR
EQ
DRIVE
MOD/PITCH DLY/REV
IN
OUT
BANK G
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK F
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK E
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK d
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK C
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK b
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
BANK A
PATCH 1
PATCH 2
PATCH 3
PATCH 4
PATCH 5
PATCH 6
