23
ZOOM 607
BASS
Adjusting
the
Expression
Pedal
The expression pedal of the 607 is adjusted for optimum operation at
the factory, but sometimes, readjustment may be necessary. If the
action of the pedal seems to be insufficient, or if a large change occurs
even if the pedal is only lightly pushed, adjust the pedal as follows.
1. While holding down the PEDAL ASSIGN key,
turn the unit on.
The indication "dn" flashes on the display.
2. With the expression pedal fully raised, press the STORE
key.
The display indication changes to "UP".
3. Push the expression pedal fully down and then lift your
foot off the pedal.
When you release your foot, the pedal goes back a little.
4. Press the STORE key.
The adjustment is completed, and the unit returns to the play mode.
The point where the STORE key is pressed in step 3 determines the
module on/off switching point. If you want the pedal to perform
on/off switching with a lighter touch, push the key at a somewhat
higher position of the pedal.
22
ZOOM 607
BASS
Restoring the Factory Defaults
Restoring
the
Factory
Defaults
The 607 comes with 42 recommended patches (factory default
patches). Even if you overwrite any of these patches, you can restore
the original contents of the patch at any time.
There are two ways of restoring factory defaults. "All Initialize" returns
the entire set of patches to the original condition. "Factory Recall"
restores a specific patch to the original condition.
1. While holding down the STORE key, turn the unit on.
The indication "AL" flashes on the display.
■
To perform All Initialize
2. Press the STORE key once more.
All patch settings are returned to the factory default condition, and
the unit switches to play mode. To cancel All Initialize, press the
VALUE [-] key.
All user-created patches will be lost when performing All Initialize.
Use this function with care.
■
To perform Factory Recall
2. Use the [
W
] / [
Q
] foot switches to select the
patch you want to return to the original
condition.
The specified bank and patch number flashes on the display.
During Factory Recall, the VALUE [+] / [-] keys cannot be used to
switch the bank only.
3. Press the STORE key once more.
The settings of the specified patch are returned to the factory default
condition.
If desired, repeat steps 2 and 3 to restore other patches. To terminate
the Factory Recall operation, press the VALUE [-] key. The unit will
switch to the play mode at this point.
NOTE
d
n
U
P
Pedal fully raised
Push strongly,
so that pedal
touches here
When foot is lifted,
pedal returns slightly
Adjusting the Expression Pedal
