1- STEPS TO DRAIN ANTIFREEZE
4
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-067093 M6×10 top pin bolt (color zinc)
1
12±1.5N.m
2
1251513-001019 6.3×12×1.6 copper gasket
1
Fig.1 STEPS TO DRAIN
ANTIFREEZE
Steps to drain antifreeze
PROCEDURE:
●
As shown in the figure, find the bolt
⑴
on the right side of the engine, use an 8#T sleeve to unscrew and
remove the copper gasket
⑵
, place a container under the drain hole, and prepare to receive antifreeze.
●
Locate the main water tank filling port on the right side of the vehicle steering column, press down and turn it
counterclockwise to remove the water filling port cap, the antifreeze will be discharged from the drain hole into
the container.
CAUTION:
●
After the gasket(2) is removed, it is best to replace it with a new one to avoid water leakage.
●
The tightening torque of bolt
⑴
is 12±1.5N.m.
●
Antifreeze is corrosive to a certain extent, so be careful not to contaminate the engine and other parts, body,
clothing, etc. when discharging the antifreeze. If parts are accidentally contaminated with antifreeze, immediately
wipe them with a clean lint-free cloth. If clothing or skin is stained with antifreeze, immediately rinse with clean
water. If the antifreeze is splashed into the eyes, immediately rinse with plenty of water and observe to decide
whether to seek medical attention.
●
The disassembly of the engine should be carried out when the engine is cold. The first is to prevent burns. The
second is that most of the oil is in the crankcase when the engine is cold. At this time, there is no need to drain
the oil when removing the cylinder head assembly and the cylinder block assembly.
